Jimbo's 4" SCC ~ ALICE

View previous topic View next topic Go down

Jimbo's 4" SCC ~ ALICE

Post  Jim the Shovel on Mon 05 Oct 2015, 4:49 pm

Haven't put up any pics as yet mainly because I haven't finished anything much yet. All in various stages of paint which we've all seen before.
As y'all know the rear wheels are a bit on the heavy side so I knocked up this upside down skateboard using 4" castors.
I put the wheels on a common axle to keep them inline. Have to keep a check on it as the wheel does tend drift a bit but on the whole pretty good.
I done the complete trial build only moving from chair to do up the spoke bolt in the hub on the farside.

I also turned some guide pins for the axle and drive pin to ensure that the cover plates are located correctly.
These were made from acetal round bar. Just the job for something which is only going to be used a few times. And it's cheap.

Jim the Shovel

Number of posts : 33
Location : Isle of Wight
Registration date : 2015-06-30

View user profile

Back to top Go down

Re: Jimbo's 4" SCC ~ ALICE

Post  LiveSteam on Thu 08 Oct 2015, 1:28 pm

Now I like that wheel holder Cool


Number of posts : 259
Location : Hampshire
Registration date : 2013-09-08

View user profile

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum