Valve Gear Correction

View previous topic View next topic Go down

Valve Gear Correction

Post  Steam Traction World on Thu 19 Apr 2012, 5:24 am

Hi All

Please note that I made an error in labeling ISO 21 which described the layout for the valve gear. As shown, the engine would run in the wrong direction for the position of the reversing lever. I have corrected the ISO so if you would like to email me at:

steve@steamtractionworld.co.uk

I will email you a pdf copy of the corrected drawing. If you have already assembled the valve gear then the error is easily corrected by swopping the two eccentric rods (BS42103-1) over where they connect to the expansion link.

Apologies for any inconvenience caused.

Regards

Steve

Steam Traction World

Number of posts : 884
Location : Daventry UK
Registration date : 2008-06-18

View user profile http://www.steamtractionworld.co.uk

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum